Basler SCOUT LIGHT User Manual Page 68

  • Download
  • Add to my manuals
  • Print
  • Page
    / 166
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 67
Image Acquisition Control
60 Basler scout light
You should be aware that if the Acquisition Frame Rate Abs parameter is enabled, the operation of
the trigger ready signal will be influenced by the value of the parameter:
If the value of the parameter is greater than zero but less than the maximum allowed, the
trigger ready will go high at the rate specified by the parameter value. For example, if the
parameter is set to 10, the trigger ready signal will go high 10 times per second.
If the value of the parameter is greater than the maximum allowed acquisition frame rate with
the current camera settings, the trigger ready signal will work as described above and will go
high at a point that represents the maximum acquisition frame rate allowed.
The trigger ready signal is not normally assigned to the physical output line on the camera. This can
be changed, however, and the trigger ready signal can be assigned to the camera’s output line.
For more information about changing the output signal assigned to the camera’s output line, see
Section 8.2 on page 88.
For more information about the electrical characteristics of the camera’s output line, see
Section 5.7.3 on page 34.
Note
If you attempt to start an image acquisition when the trigger ready signal is low,
the camera will simply ignore the attempt.
The trigger ready signal will only be available when hardware triggering is
enabled.
Page view 67
1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 165 166

Comments to this Manuals

No comments